Sony AIT Autoloader LIB-D81 Kurzanleitung Seite 18

The message display changes as follows and the
startup process begins. (Startup takes several
minutes.)
During startup, the following appears on the
message display.
Moves gradually up and down during the elevator check.
Indicates the startup phase, from 0 to 3.
When startup is complete, the message display
indicates the number of cartridges in the AIT
autoloader.
Starting up
Startup complete
When startup is complete, press the DOOR button
to open the front door and insert cartridges. For
details, refer to the "Operating Instructions" (PDF).
2
After pressing the power switch on the rear panel of
the autoloader, wait at least 10 seconds before
turning on the host computer.
Notes
• If you start the host computer before the autoloader,
the SCSI ID is not detected correctly. Therefore,
always start the autoloader before starting the host
computer.
• If the autoloader does not work as above, refer to
"Troubleshooting" in the "Appendix" of the
"Operating Instructions" (PDF).
18
Turning the Power On/Off
Turn Off the Power
Press the power switch on the rear of the AIT autoloader
to turn it off.
Caution
Do not turn off the AIT autoloader when it is in use or
there is a cartridge in the AIT drive, as this could damage
data.
Note
After turning the AIT autoloader off, wait at least 10
seconds before turning it on again.