Display And Operating Elements; A) Monitor - Conrad 75 16 59 Bedienungsanleitung

6. Display and Operating Elements

a) Monitor

See the front, fold-out page for the illustrations.
1) Display
2) „MENU" button
Call the menu or leave the menu
3) Button „VOL-"
Decreases the volume
4) Button „VOL+"
Increases the volume
5) ON/OFF button
This button is used to switch on the
monitor or to the standby-mode, as
long as a proper operating voltage
(same function as the „POWER"
button on the remote control) is
available.
6) Button „CH-"
Button for selecting a channel; it is
also used for navigation within
menus.
7) Button „CH+"
Button for selecting a channel; it is
also used for navigation within
menus.
The monitor's stationary mounting base can be attached by
using the three fixing holes on the bottom. Make sure that
cables or wires are not damaged when drilling or bolting in
place.
30
8) „INPUT" button
Button for selecting the video input
source.
9) LED „POWER" and „IR-receiver"
Lights up as soon as the monitor is
turned on. Is not lit in Standby
10) AUDIO input (right)
11) VIDEO input (Cinch)
12) S-VIDEO input
13) VGA input
14) Connection for power supply
12 V/DC
15) AUDIO input (left)
16) PC Audio input
17) Headphone output (3,5 mm cinch
connection)
18) Antenna input