Plastimo P180S Eignerhandbuch Seite 6

SIDE JOINER ASSEMBLY FOR P240KH, P270KH, P270HH, P310HA, P340HA and P380HA
1. Inflate the air chambers up to ¾ of their
capacity.
2. Slide an oar (a) under the bottom of the
boat to raise the floor boards (b) over the
flat surface. Attach side joiners (c). Repeat
the procedure on opposite side of the
boat. In case of more than one joiner on
each side, start with one long, one short
joiner on one side and with one short and
one long on the other side (asymmetric).
3. Install the seat (which is an option on
certain models).
4. Finish inflating the air chambers one after
the other in order to maintain equal
amount of air. DO NOT inflate any
chamber to full capacity at the one time.
Install valve caps.
5. Inflate the keel and close valve caps.
ASSEMBLY FOR PRI240V, PRI270V, PRI310RF , PRI310RH, PRI310V, PRI310VH, PRI340V,
1. When using the boat for the first time, fully inflate it by attaching the foot-pump to each of the valves, one at the time,
and when pumping, ensure that a balance of pressure between the chambers is maintained until the boat has been fully
inflated.
2. Check the working pressure with the pressure gauge.
ASSEMBLY FOR P240LJ, PI230VB, PI270VB, PI320VB and PI350VB
1. Inflate the tubes up to the working pressure of 0,25 bar, as shown before.
2. Inflate the floor chambers up to the working pressure of 0,80 bar, using a high pressure pump.
NOTE : The boat should be clean and dry before rolling up for storage. Remove any sand and debris.
1. Unscrew all air valves to deflate the boat.
2. Remove the seat, if there is one.
3. Remove side joiners from floor boards.
4. Raise one of the middle floor boards. Remove floor boards. Remove bow and transom boards last.
5. Put floor boards, side joiners and oars in carrying bag.
6. Using the foot pump as a suction device, remove excess air from each chamber.
7. With the boat now flat, tuck the tube where the oar locks are into the boat. Roll up the boat from either end and place
it in the carrying bag along with the pump.
Rinse your boat when possible, after each use. At the end of a season, wash it out in soapy water or with washing-up
liquid. Rinse, let dry before folding up the boat. Store in a dry place.
IMPORTANT : DO NOT use a vinyl preserving agent on fabric surfaces. Chemicals in such agents will
dry out the fabric.
37295_03.cdr
25 novembre 2008
C
Side joiner of P240KH, P270KH,
P270HH, P310HA, P340HA AND P380HA
PRI340VH, PRI350RF and PRI350RH
DISASSEMBLY
CLEANING PROCEDURES
6
B
A