Assembly; Assembling The Curved Handle; Operation; Hanging On/Removing The Grass Bag - FLORABEST FRM 1800 B2 Originalbetriebsanleitung

GB
outdoor use. The power cable
wire cross section must be at least
2.5 mm . Always completely
2
unroll cable drums before use.
Check the cable for damage.
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
The extension cable can be
accidentally severed. Risk of
electric shock!
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do not
touch a damaged power cable
when it is connected to the mains.
A damaged power cable may
result in contact with live parts.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.
2 8

Assembling the Curved Handle

1. Remove the two pre-installed
B
mower housing (7). Insert the
lower bar (3) into the slot on the
lawnmower housing (7).
2. Fix the bottom bar (3) using the
3. Tighten the loop handle (1) with
C
the enclosed carriage bolts (16)
and two locking levers for beam
attachment with washer (2b) to
the lower beam (3).
4. Clip the cable hooks (
the bar (3) and the handle (1) to
fasten the cable.
When both wing nuts are loosened,
the curved handle can be folded down
for storing the equipment. Ensure that
the power cable is not caught.

Operation

Hanging On/Removing the
Grass Bag
1. To hang on the grass bag (4), lift
D
the collision guard (9) and hang
on the grass bag. Fold the colli-
sion guard (9) onto the grass bag
(4). It holds the grass bag in the
correct position.
2. To remove the grass bag (4), lift the
collision guard (9) and detach the
grass bag. Fold the collision guard
(9) back onto the mower housing.
Do not work with the lawn-
mower without the collision
guard or lawn box. There is a
risk of injury.
2 -
2 ).
10) into
A