Cameo MATRIX 300 RGB Bedienungsanleitung Seite 8

SYSTEM SETTINGS AND SYSTEM INFORMATION
To adjust system settings and access system information, press MODE repeatedly until "Sett" appears in the display. Confirm by pressing
ENTER. You can now use UP and DOWN to select and edit one of the following menu items:
-> ENTER ->
UP/DOWN
<- MODE
8
-> ENTER ->
UP/DOWN
<- MODE
Display is rotated
by 180°
(overhead installation)
-> ENTER ->
UP/DOWN
<- MODE
on = display permanently on
off = display goes off after ap-
prox. 60 seconds of inactivity
-> ENTER ->
UP/DOWN
<- MODE
This menu option allows you to define
which operating mode is to be enabled if
the DMX signal is interrupted in DMX mode.
-> ENTER ->
UP/DOWN
<- MODE
Set
dimmer curve
-> ENTER
<- MODE
Displays
firmware version
-> ENTER
<- MODE
Displays device
temperature in °C
-> ENTER
<- MODE
Displays total
operating time in
hours
-> ENTER
<- MODE
LED test
Functional test of all
LEDs from 1 to 25.
Display flashes
during test. Press
MODE or ENTER
to stop.
The last DMX command Blackout
is retained
dimmer curve dimmer curve
linear exponential
Light intensity Light intensity can
increases linearly be finely adjusted
with DMX value. at lower DMX
values and broadly
adjusted at higher
DMX values.
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
Auto programme
dimmer curve S-curve
logarithmic Light intensity can
Light intensity can be finely adjusted
be broadly adjusted at lower and higher
at lower DMX values DMX values and
and finely adjusted broadly adjusted
at higher DMX at medium DMX
values. values.
-> ENTER
<- MODE