Connections, Operating And Display Elements; Led Display - Cameo MATRIX 300 RGB Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

2 1
1
POWER IN
Blue power input socket for power supply to the device. A suitable power cable is included.
2
POWER OUT
White power output socket for the power supply of additional CAMEO spotlights. Ensure that the total
current consumption of all connected devices does not exceed the value specified on the device in amperes (A).
3
FUSE HOLDER
IMPORTANT: Replace the fuse only with a fuse of the same type and of the same value according to the stamp on the device! In the event of
repeated fuse failure, please contact an authorised service centre.
4
POWER
On/off switch.
5

LED DISPLAY

The four-digit LED display shows the operating mode and other system information.
6
OPERATING KEYS
MODE: Selection of the main menu items. Move up one level in the menu structure.
ENTER: Confirms programme selection and value changes.
UP and DOWN: Selection of operation mode and system settings, e.g. changing of microphone sensitivity and DMX address.
7
MIC
Microphone for music control mode
8
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
9
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
10
DMX IN
Male 5-pin XLR socket for connection to a DMX control device (e.g. DMX console).
11
DMX OUT
Female 5-pin XLR socket for sending the DMX control signal.
12
FAN
There are three case fans on the back of the device. Ensure that the fans are not covered and that air can circulate freely.
13
VENTILATION SLITS
Ensure that the ventilation slits are not covered and that air can circulate freely.
3
7
4
11
9 8
10
5
6
5