Slave Mode; Sound Control Mode; Colour Balance - Cameo MATRIX 300 RGB Bedienungsanleitung

CONFIGURE DMX MODE
Press MODE repeatedly until "ChAn" appears in the display. Now press ENTER and select the desired DMX mode using UP and DOWN as
required (DMX 03Ch, 05Ch, 19Ch, 28Ch, 78Ch). Confirm your entry by pressing ENTER.
Tables with the channel assignment of the different DMX modes can be found in these instructions under DMX CONTROL.
-> ENTER-> UP/DOWN

SLAVE MODE

Press MODE repeatedly until "SLAV" appears in the display and confirm by pressing ENTER. Connect the slave and master units (same model)
using a DMX cable and enable the standalone mode SOUND CONTROL on the master unit. The slave unit will now follow the master unit. If there
is no control signal, the display characters will flash. Flashing stops as soon as a control signal is present.

SOUND CONTROL MODE

Activate sound control mode to control the spotlight via the built-in microphone (bass impulses) and set the microphone sensitivity as required.
Press MODE repeatedly until "SoUn" appears in the display and confirm by pressing enter. Now use UP and DOWN to select "Soun", press
ENTER and then use UP and DOWN again to select "on" or "oFF" to activate or deactivate sound control. Confirm by pressing ENTER. Now use
UP and DOWN to select "SenS", the menu item for microphone sensitivity, confirm by pressing ENTER and use UP and DOWN to set the desired
level (1 = minimum sensitivity, 99 = maximum sensitivity). Confirm by pressing ENTER.
-> ENTER-> UP/DOWN

COLOUR BALANCE

Cross-mode calibration of colour reproduction with mixed colours. Press MODE repeatedly until "baLa" appears in the display and confirm by
pressing ENTER Now select the colour whose intensity you wish to change using UP and DOWN (red = red, Gree = green, bLue = blue) and confirm
by pressing ENTER. Use UP and DOWN once again to set the colour intensity from 0 to 255 and confirm by pressing ENTER.
-> ENTER-> UP/DOWN
INVERTED DISPLAY
This function can be used to display letters, numbers and symbols horizontally, vertically or horizontally and vertically inverted on the LED
matrix panel. Press MODE repeatedly until "Inve" appears in the display and confirm by pressing enter. Now use UP and DOWN to select the
desired option and press ENTER to confirm.
-> ENTER-> UP/DOWN
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
Inversion Horizontal
deactivated inversion
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
Vertical Horizontal and
inversion vertical inversion
-> ENTER
<- MODE
7