Boiling Water - Silvercrest SWKT 3000 A1 Bedienungsanleitung

GB

Boiling water

IE
CY
8
DANGER – ELECTRIC SHOCK!
NEVER place the electrical base 5 in close proximity to water – risk of
►
fatal electric shock!
WARNING – RISK OF INJURY!
► Always use fresh drinking water. Do not consume any water that has al-
ready stood in the kettle for longer than one hour. Do not reboil water that
has cooled down. Always pour old water away. It may contain germs!
NOTE
Always ensure that the ON/OFF switch 3 is in the "O" position when the
►
mains plug is unplugged and the appliance is standing on the base 5. If
not, the appliance could heat up unintentionally as soon as the mains plug
is plugged in again.
1) Lift the kettle off the base when fi lling it!
2) Open the lid 1 by pressing on the lid release button 2.
NOTE
► When fi lling, hold the kettle upright. This is the only way to read the mark-
ings on the scale 7 correctly.
3) Fill the kettle...
– to at least the MIN mark, so that the appliance does not overheat,
– no further than the MAX mark, so that boiling water cannot spill out.
4) First close the lid 1 and then place the kettle on the base 5 in such a man-
ner that it sits securely on the base 5.
5) Adjust the temperature control 6 to the required setting. To bring the water
to the boil, set the temperature control 6 to the MAX position in the boiling
range (area marked red on temperature control 6).
6) Now insert the plug into the mains power socket.
7) Press the ON/OFF switch 3 downwards so that it engages.
8) The control lamp 4 indicates that the appliance is now heating the water up.
WARNING – RISK OF INJURY!
For safety reasons, the lid 1 should not be opened while the water is boiling
►
or is very hot. There is a risk of scalding.
SWKT 3000 A1