Kenwood BLM80 Bedienungsanleitungen Seite 7

before plugging in
Make sure your electricity supply is the same as the
l
one shown on the underside of the appliance.
WARNING: THIS APPLIANCE MUST BE
l
EARTHED.
This appliance conforms to EC Regulation 1935/2004
l
on materials and articles intended to come into contact
with food.
key
filler cap
1
lid
2
goblet
3
sealing ring
4
blade unit
5
blade base
6
Power On indicator
7
speed + pulse control
8
power unit
9
drinks programme button
k
soups programme button
l
ice crush programme button
m
fine chop programme button
n
coarse chop programme button
o
rinse programme button
p
vents
q
stir stick
r
cord storage device
s
to use your blender
1 Fit the sealing ring
4
the seal is located correctly in the grooved area. Then
fit the blade unit into the goblet
Leaking will occur if the seal is damaged or
l
incorrectly fitted.
2 Screw the blade base
blade assembly is fully tightened. Refer to the graphics
on the side of the blade base as follows:
- unlocked position
- locked position
3 Put your ingredients into the goblet.
4 Fit the filler cap to the lid and push down to secure.
5 Fit the lid by pushing down until secure.
6 Place the blender onto the power unit.
Ensure the cord is fully unwound from the
l
cord storage device before using the blender.
The appliance will not work if the blender is
l
incorrectly fitted.
into the blade unit - ensuring
5
.
3
onto the goblet – ensuring the
6
7 Plug in and the Power On indicator
Note: The Power On indicator will flash if the goblet is
not fitted to the power unit. Select a speed (refer to the
recommended speed chart).
8 Choose one of the following options:
Programme buttons:- Turn the speed control to the
l
'On' position and all the buttons will light up. Press
the required programme button and the lights on the
other buttons will go out and the programme will start.
The blender will switch off automatically at the end
of the programme time. If you wish to stop before
the programme time has elapsed, press the selected
programme button again.
Manually selected a speed by turning the speed
l
control until the required speed is reached. At the end
of blending return the speed control to "O" before
removing the blender.
Do not remove the goblet until the blades
l
have stopped rotating and the speed control
is in the 'O' position.
(P) Pulse – operates the motor in a start/stop action.
l
The pulse will operate for as long as it is held in
position.
Refer to the troubleshooting section if you
experience any problems with the operation of
the blender.
to use the stir stick
1 Fit the lid to the goblet and remove the filler cap. DO
NOT use the stir stick in the goblet without the lid fitted.
2 Insert the stir stick
slowly whilst the motor is operating.
3 Use the stir stick to help move ingredients around the
goblet and prevent clogging during processing.
hints
To blend dry ingredients - cut into pieces, remove
l
the filler cap, then with the machine running, drop the
pieces down one by one. Keep your hand over the
opening. For best results empty regularly.
When making mayonnaise, put all the ingredients,
l
except the oil, into the blender. Remove the filler cap.
Then, with the appliance running, add the oil slowly
through the hole in the lid.
Thick mixtures, e.g. pâtés and dips, may need scraping
l
down. If the mixture is difficult to process, add more
liquid and use the stir stick supplied.
5
will light up.
7
and move it round the goblet
4