Function And Itself State Will Be Shown In Display Area - Sanotechnik H90W Montageanleitung

1) Put plug into socket and press REST of electric leakage protection. Both the indicator lamp of the electric
leakage protection and the indictor lamp of power source on operational control panel with light.
2) Turn on power key
Choose some keys you need operating and push power key
3) Note: All functional keys being working will be also turned off except fan starting working automatically
meanwhile the power source is off. After one minute, the fan will turn off automatically and drainage water in
steam machine (about 100 seconds).
4) Enactment time
5) Push key to delay working time of steam bath. The time limit is 00-60 minutes. The steam will stop
automatically when the time is to 00 min. The inner enactment time is 25 min.
6) Enactment temperature
7) Push to fax highest temperature and the limit is 45-60℃. The steam will stop automatically when the
temperature in bathroom reaches fixed degree. The fixed temperature inner steam generator is 45C.
8) Note: The temperature of bathroom will be shown in the display area when the stream generator starts working.
Push and the fixed temperature will shown in this area. But the temperature comes back after 5 seconds.
9) Push to turn on/off the steam function.
10) Push to turn on/off the respectively
11) FM radio
Push to turn on/off FM radio
Push or to strengthen or weak the radio volume
Push to choose high frequency and press
high frequency

Function and itself state will be shown in display area

Operational explanation
and working time of steam bath and temperature in bathroom are shown in display area.
once again to turn off power source.
to go back low frequency, but press once again to go back
Page 5