Measuring The Temperature - geo-FENNEL FMM5 Bedienungsanleitung

EN
MEASURING THE HUMIDITY
1. Set the power/function/range switch to "%RH" position.
2. Then the display will show the humidity reading value (%RH) directly.
3. When the tested environment humidity value changes this is due to temperature fluctuation. Wait
some minutes and you will get the stable "%RH" reading.

MEASURING THE TEMPERATURE

1. Set the power/function/range switch to "0,1°C or °C" position.
2. Then the display will show the environment temperature reading value (°C) directly.
3. Connect the black plug of temperature probe the COM jack and red plug to the " V / Ω / mA / °C "
jack.
4. Touch the end of the temperature sensor to the area or surface of the object to be measured. The
display will show the temperature reading value (°C) directly.
MEASURING THE VOLTAGE
1. Connect the black test lead to the COM jack and red lead to the "V/Ω/mA/oC" jack.
2. Set the function switch at DCV or ACV ranges to be used and connect test leads across the source
or load under measurement.
3. Read LCD display. The polarity of red connection will be indicated when making a DC measurement.
CAUTION
To avoid damage to the meter, don't apply input which exceeds the limit shown below:
Function
DCV/ACV
Ω /CONTINUITY/
DIODE
DCA
A
MEASURING THE CURRENT
1. Connect the black test lead to the COM jack and the red test lead to the "V/Ω/mA/oC" jack for a
maximum of 200mA. For a maximum of 10A,move the red lead to the "10A" jack.
2. Set the function switch at uA, mA or A range to be used.
3. Connect test leads in series with the load in which the current is to be measured.
4. Read LCD display. The polarity of red lead connection will be indicated.
18
Red lead
connection
"V/Ω/mA/oC"
"V/ Ω//mA/oC"
"V/Ω/mA/oC"
"10A"
Input limits
600V dc or ac rms.
250V dc or ac rms.
200mA dc or ac rms.
(0,2A/250V fuse protected)
10A dc or ac rms.
(10A range unfused)