Coitech ST12 Bedienungsanleitung Seite 9

4. Adjust the lower bearing (26) on the mitre
gauge table so the table can slide freely but
not too loosely.
6. Align the sliding mitre table so that it is parallel
to and level with the tabletop. Adjust it by
moving the slider rail. Extend the mitre gauge
fence to check that the two tables are level.
When the slider rail has been adjusted, the four
bolts (30) can be tightened. The two wing nuts
(29) on the mitre gauge can be used for fine-
adjustments.
7. Set the mitre gauge at 90º to the saw blade
by swivelling it up to the cam head bolt (31) in
the corner of the mitre table. Check that the mitre
gauge is at right angles by placing a try square
against the saw blade. If necessary, adjust
the cam head bolt by undoing the nut under
the mitre table. Test the angle on a piece of
waste stock and fine-adjust if necessary.
26
5. When attaching the mitre gauge (27) to the sliding
9
27
28
table, place the two plastic washers (28) between
them. Finger-tighten the bolt nearest the table saw
so the gauge can swing round. Tighten the other
bolt which is attached to the locking handle so
that the mitre gauge is locked in position when
the handle is depressed and can swing round
when the handle is lifted.
29
30
31