Coitech ST12 Bedienungsanleitung Seite 7

Accessory hook
Attach the accessory hook (15)
for hanging the blade spanner
and push stick on to the outside
of the right front leg using 2 of
the M6 nuts and washers (one nut
on the inside of the leg and one on
the outside).
Transportation handles
Attach the two folding transportation
handles (16) to the face of the front
legs using 4 of the M6 × 16 mm bolts,
M6 nuts and washers.
Rip fence
1. To attach the rip fence rail to the table
you will first need to bolt the clamp (17) to
the tabletop. Bolt one of the rip fence clamp's
holders to the tabletop using an M6 × 30 mm
socket head bolt, nut and washer and then slide
the pin on the end of the clamping handle into
the hole in the holder.
2. Then bolt the other clamp holder onto the tabletop
using the other M6 × 30 mm socket head bolt, nut
and washer.
3. Attach the rip fence to the rip fence rail (19) by
sliding it onto the slider plate (18) which is bolted
on using two M6 × 50 mm coach bolts, washers
and wing nuts.
4. The rip fence (20) can be mounted in two
positions, low profile
20
7
15
17
18
or high profile. Secure the rip fence to the rail by
tightening the wing nuts.
16
19