On/Off Switch - Coitech ST12 Bedienungsanleitung

Assembly
Note: Make sure that the saw is disconnected from the power supply before assembly, adjustment or servicing.
Legs
1. Lay the tabletop (1) onto a workbench and
remove the wrapping (a) from around the motor.

On/off switch

Attach the on/off switch (3) to the tabletop using 2 of
the M6 × 16 mm bolts, M6 nuts and washers.
Cross members
Fit the cross members (4), 2 long and 2 short, to the legs using 12 of the M6 × 16 mm bolts with nuts
and washers. Finger-tighten the bolts.
4
a
1
2. Attach the 4 legs (2) using the supplied M6 × 16 mm
bolts, M6 nuts and washers. 2 bolts hold each leg
in place. Finger-tighten the bolts.
4
2
3