Coitech ST12 Bedienungsanleitung Seite 12

Note: The blade guard in the pictures has been removed only for the purposes of allowing a clearer view of
the method of operation or construction.
Sawing wide workpieces
• Set the rip fence.
• Make sure that your left hand is resting on a firm
surface to steady you. If narrow offcuts are
produced during the sawing, the workpiece may
only be fed through the blade using your right
hand or with the help of a push stick.
Sawing narrow workpieces
• Set the rip fence.
• Feed the workpiece through the blade with
both hands.
• When your hands begin to near the blade, you
should use a push stick to feed the workpiece
past the blade in a steady motion.
Sawing edging and moulding
• Set the rip fence to the low profile.
• Feed the workpiece into the blade using the push
stick until the edge of the workpiece is in the area
of the riving knife.
• Make sure that long workpieces do not fall
onto the floor after sawing by attaching a table
extension onto the table.
Crosscutting narrow workpieces
Use the mitre gauge to guide you whenever making
any kind of crosscut.
Note: Never remove offcuts from around
the saw blade with your hands.
Sawing bevels, grooves, rebates, etc
• When ripping a bevel, the cut should be made
so that the cut-off strip falls away from the main
workpiece on the opposite side of the blade to
the rip fence.
• When cutting grooves or rebates, remove
the blade guard and lower the saw blade to
the desired height. Make sure that the workpiece
can be fed over the blade without dificulty.
12