VDO Cyclecomputing z3 Bedienungsanleitung Seite 51

EN
Problem when pairing the pulse-
chest belt
No speed display
42
- Check the battery in the chest
belt
- Check the battery in the
computer (if battery voltage is
insufficient then the receiver
cannot receive the signals)
- Check the magnet position
(distance between magnet
and transmitter, position of the
magnet to the transmitter point
on the transmitter)
- Check the battery in the
transmitter
- Check the battery in the
computer (if battery voltage is
insufficient then the receiver
cannot receive the signals)
No cadence display
No speed display (dash in the
display)
No cadence data (dash in the
display)
- Check the magnet position
(distance between magnet
and transmitter, position of the
magnet to the transmitter point
on the transmitter)
- Check the battery in the
transmitter
- Check the battery in the
computer (if battery voltage is
insufficient then the receiver
cannot receive the signals)
The receive channel for speed is
switched off (a 15-minute period
has elapsed without receiving a
speed signal)
Press buttons ¥ + ç at the
same time
The receive channel for cadence
is switched off (a 15-minute
period has elapsed without
receiving cadence signals)
Press buttons ¥ ç at the
+
same time