Installation; Unpacking / Site - Pkm WA7-E1214 Bedienungsanleitung

 The manufacturer and distributor are not responsible for any damage or
injury in the event of failure to comply with these instructions.

2. Installation

WARNING! Remove the safety bolts before initial use (see chapter
2.2 R
EMOVING OF THE SHIPPING BOLTS
cause serious injury to persons and/or severe damage to the appliance.
Important information: The installation of this appliance must be carried out by
a person who is experienced in such a work
intended for such a person. The manufacturer is not liable for any damage caused
by improper installation.

2.1 Unpacking / Site

1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Check that the appliance and the power cord are not damaged.
3. Do not install the appliance in a bathroom or a place where it may come in
contact with water or rain; otherwise the insulation of the electrical system will
be damaged. Do not install the appliance in a room where explosive or
flammable gases are stored.
4. Protect the appliance from direct sunlight.
5. Install the appliance in a dry and well-ventilated place. The room temperature
must be higher than 0
6. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
7. Do not install the appliance on a carpet / fitted carpet.
8. Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
9. All required installations for the electric and water supply must be carried out
by a qualified professional.
10. Connect the appliance to the mains properly.
11. The nameplate is situated at the back of the appliance.
11
Not included in guarantee.
0
C.
.
50
); otherwise the appliance may
11
. The following instructions are