Possible Faults - Scheppach PM1600 Originalbetriebsanleitung

Storage
• The whole machine and all accessories must be tho-
roughly cleaned.
• Store the machine always out of children's reach.
Put it in a secure position in a dry and safe place
where no extremely high or extremely low tempera-
tures may occur.
• Protect the stored machine from direct sunlight; put
it in a darkened area, if feasible.
• Do not wrap the machine into bags or covers made
of nylon or plastic, as dampness may develop.

Possible faults

Problem
Motor does not start.
Unusual vibrations
Device starts but blocks under
slight load and cuts off automa-
tically.
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch defect
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or crosssection
too small.
Socket too far away from main connection,
and cross-section of connection lead too
small.
Remedy
Check fuses
Exchange defect cable, respectively check
extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the manuf-
acturer or other approved service centre.
Replace the beater.
To correct the problem, refer to the manuf-
acturer or other approved service centre.
Incorrect processing. Follow the processing
instructions from the supplier.
Extension cable at least 1,5 mm
25 m long.
Cross- section of at least 2,5 mm
cables.
, maximum
2
in longer
2
15 І 60