Inhaltsverzeichnis
Werbung
A.1 Trouble Shooting
Occasionally receivers can hang-up (just like with a PC) so you are recommended to reset the receiver by disconnecting it from
mains power. Wait 30 seconds and connect to mains power again and now check if the unit is working as expected. If the receiver
does not work properly after checking the trouble shooting section, please contact the dealer. Don't open the receiver cover, it may
cause an electrical shock due to high current voltage and the warranty of your receiver will be void if the receiver has been opened
Symptoms
Cause
The green/red lights on front
The power cord is not
panel do not light up.
plugged in.
No picture and sound
TV is set to wrong channel.
No picture and sound.
Problem in cable connections
between receiver and TV
No picture and sound
Receiver "hang-up"
No sound
The receiver or TV is in
"MUTE"' mode
No sound or picture
Problem in scart cable con-
nections between receiver and
TV
No picture.
Wrong alignment of the dish.
The receiver displays the
This is normal, the bad weath-
message "No or Bad signal"
er is interfering the signal
during bad weather condi-
between the satellite and your
tions (heavy rain or snow)
dish
The receiver displays the
Wrong satellite selected in the
message "No or Bad signal"
menu.
The receiver displays the
Wrong parameters set in the
message "No or Bad signal"
menu.
The receiver displays the
Wrong alignment of the dish.
message "No or Bad signal"
The RED and Green lights on
Overload of the maximum
the front panel of your receiv-
available LNB power. (Short
er are blinking
circuit in the LNB cable)
The remote control is not
The batteries of the remote
working
control are not inserted or
exhausted
20
Solution
Check that the power cord is plugged into the wall outlet.
Check if the TV is switched on and set your TV to the correct EXT / AV
or UHF channel.
Check if the scart and/or RF cable is connected correctly to the TV and
to the back of the receiver.
Switch off receiver; disconnect the main power cord of the receiver
from the 220V main power. After 30 seconds reconnect to the main
power and check if it is working properly.
Press the MUTE button on the remote control unit of your receiver and
TV.
Firmly press the scart connectors on the backside of the TV and receiv-
er. Replace the scart cable
Check the signal strength with a spectrum analyser and adjust your
dish correctly.
Once the weather is better the picture will appear. If not : check if there
is no snow on your dish
Press the SAT button on the RCU and select the correct satellite
Check settings in LNB- and Channel set up menu.
Ask your dealer to check the outdoor unit and antenna cable to LNB
Disconnect the 220V main power and ask your dealer to check the
LNB cable.
Check whether the batteries are inserted correctly in your remote con-
trol. Check the batteries, and if they are exhausted, replace them.
PART 1 • English
Werbung
Inhaltsverzeichnis
