Inhaltsverzeichnis
Werbung
Set up guide
1.0 Warning
Never open the cover. It is dangerous to touch the inside of the receiver due to high voltage currents and
n
possible electrical hazards. Your warranty will be void if the receiver has been opened.
Do not install your receiver in a closed or poorly ventilated cabinet
n
Do not install your receiver near direct sunlight or near any other equipment that generates heat
n
Do not expose your receiver to rain or intense moisture
n
Do not use alcohol or ammonia based liquids to clean the receiver.
n
Please ensure that that the electrical power supply corresponds with the voltage on the electrical identification
n
plate at the back of the receiver.
When you are connecting the cables, be sure that the receiver is disconnected from the mains supply voltage.
n
2.0 Connecting to your TV & VCR
If you are not sure how to connect your receiver, do not take the risk of doing
it yourself. Ask your Strong dealer to do it for you. Do not hesitate to ask any
questions you have to your Strong dealer about installing your receiver.
The easiest and the quickest way to connect the receiver is through the use
of SCART cables as shown below:
Connect the satellite signal from the LNB to the LNB IN connector.
n
Connect the TV scart connector at the back of the receiver to the
n
scart connector on your TV set.
Connect your TV and receiver to the power plug and switch it ON.
n
3.0 Starting up
To offer you the best service, we have already pre-programmed the TV and Radio channels from the Astra and Hot
n
Bird satellites. However, it may be that for some countries the channels are not pre-programmed.
If dish is on ASTRA: The receiver will start up with channel 1(channel from ASTRA). If dish is on HOTBIRD: NO
n
SIGNAL message will appear. Using UP/DOWN keys on your remote, find the first Hotbird channel (usually it's
channel 400).
If your dish is aimed at another satellite, you will see the message "No channels" this is because the receiver is set
n
to factory default settings. The default language is set to English, to choose other languages refer to "Language
settings" description below.
To download the channels, please refer to "Channel Set-up"
n
Note: Every time the receiver asks you to put your PIN code, enter '1234' on your remote control using [0-9]
numeric keypads.
3.1 Language Settings
When you first turn on the receiver, the "Language Settings" menu will appear on the screen. To change the menu
language of your receiver, applying the following steps:
Select "Menu Language", press OK to choose a language and press EXIT to go to main menu.
n
3.2 Channel Set-up
The channel set-up is for downloading the channels available on the satellites. Please apply the following steps:
1. Press the Menu button, select "Installation", select "Channel Set-up" and press OK.
Satellite: Select "Satellite" and press OK.
n
PART 6 • Quick Set Up Guide • English
www.strongsat.com
Werbung
Inhaltsverzeichnis
