Hartan Yes GTX Bedienungsanleitung Seite 9

Instructions for use
WARNING!
When opening out and folding down the frame and when adjusting the back­rest,
pinch­points may be caused in which fingers etc. can be trapped unless care is exercised. Ensure that
your child has plenty of clearance space.
unfolding the carriage
Lift the handle 1 until the two lateral handle catches 2 have engaged.
WARNING!
Before using the pram, make sure all catches are locked. Take care that you keep your
child's body parts at a safe distance.
Folding the carriage
Turn the twist grip 3 inwards and push at the same time the telescopic handle to the stop. With the grip 3
still twisted, depress the red button 21, and push the handle 1 forcibly until it disengages.
Height-adjustable Telescopic handle
Turn the twist grip 3 inward and slide the handle 1 in the desired position until it engages on both sides.
Changing the rear wheels
Release the parking brake 7. Depress push button 4 and pull the wheel off. Push the wheel right to the
axle's stop. Make sure, all wheels are held in place properly. Then, depress the button again.
Lock-type-swivel wheels
Turn down the lock lever 5 to pre­select the straight­line motion mode, which
will be activated the moment the wheels point in forward direction. To allow the
wheels to swivel freely again, turn the lever 5 back to the horizontal position.
On very uneven surfaces, and when going very fast, we recommend locking the
swivel movement, to prevent the wheels from blocking.
Changing the swivel wheels
To remove the wheel, release the push­button in the centre of the
cap 6 and pull the wheel off the holding device. To assemble the
wheel, insert the fastening pin in the holding device, and engage it
by a forcible push, which is indicated by a click sound.
Parking brake
Push the red brake button 7 to engage the brake. Having parked the
pram, try to push it to check the brake. Push the green brake button
7 to release the brake.
WARNING!
Make sure the brake is always closed when placing
the baby in the carriage or taking it out of it.
Adjustable suspension system
By turning the selector 8, a „hard" or „soft" position can be selected
for suspension.
Hood and safety bar
By pressing the bayonet joint 12, the hood or the safety bar can be pulled out. When inserting it, make sure the
safety bar locks into place correctly and be careful not to pinch any of the fabric parts. By pressing the buttons
11, the safety bar position can be changed.
WARNING!
The hood bar of the stroller and the safety bar are not suitable for carrying the stroller.
8
5
8 7 8