TARGET
8' LAP
(slow)
ACTUAL
START
LAP 1 (10'00)
-2'00 (slow)
Setting the Target Time Pacer
1. Press MODE until CHRONO appears (Chrono reads 00:00:00 or press
STOP/RESET to reset).
2. Press SET to start setting.
3. Press MODE (NEXT) button until TARGET TIME appears.
4. Press START/SPLIT (+) or STOP/RESET (-) to turn TARGET TIME ON or
OFF.
24
(on pace)
(fast)
LAP 2 (8'00)
LAP 3 (7'00)
FINISH
(on time)
+1'00 (fast)
5. If you select ON, press the MODE (NEXT) button until
Target Pace (TRGT PACE) appears.
6. Press START/SPLIT (+) or STOP/RESET (-) to enter the
Target Pace per lap time in hours (HH), minutes (MM)
and seconds (SS). Target Pace per lap can be set from
a minimum of 1 minute (1.00) to a maximum of 1 hour
(1:00.00).
7. Press MODE (NEXT) button to enter the (TRGT RANGE) which is the
margin of error (+/-) you are willing to consider your lap as
"ON-PACE". When Target Range appears, enter minutes (MM) and
seconds (SS).
8. Press MODE (NEXT) button until Target Distance (TRGT DIST) appears.
9. Press START/SPLIT (+) or STOP/RESET (-) to select either NONE or
SET.
10. If you select SET, press MODE (NEXT) button until Unit Distance (UNIT
DIST) appears.
E
25