Extension Kit "Linear Actuator" 6Dr4004--8V And 6Dr4004--8L - Siemens SIPART PS2 6DR50x0 serie Betriebsanleitung

Operating instructions
External position sensor
There are potential cases for which the above--mentioned measures are not sufficient. This could be, for example,
in the presence of strong and lasting vibrations, increased or too low ambient temperatures, and in the presence
of nuclear radiation.
In such cases, separate mounting of position sensor and control unit is helpful. For this, a universal component
is available that is suitable for both linear and rotary actuators.
You will need the following:
The position sensor unit (order number C73451-A430-D78). This consists of a SIPART PS2 housing with
-
an integrated friction clutch, in-built potentiometer and various blind plugs and seals.
The control unit, a SIPART PS2 positioner in any version.
-
The EMC filter plate which is available in a set together with cable clamps and M-20 cable glands and has
-
the order number C73451--A430--D23. The EMC filter plate must be mounted in the SIPART PS2 positioner.
The Installation Instructions supplied with the EMC filter plate explains the assembly of the components.
A three-pin cable to connect the components.
-
This upgrade set must also always be used for the control unit when any potentiometer (resistance value
10 kOhm) is mounted on the actuator instead of the position sensor unit C73451-A430-D78.
3.2

Extension Kit "Linear Actuator" 6DR4004--8V and 6DR4004--8L

The following are included in the delivery of the extension kit "Linear actuator IEC 534 (3 mm to 35 mm)" (see
Figure 3 for item Nos.):
Item No. Quantity Designation
1 1 NAMUR mounting brak-
ket IEC 534
2 1 Pick-up bracket
3 2 Clamping assembly
4 1 Driver pin
5 1 Roll
6 1 NAMUR lever
7 2 U-bolt
8 4 Hexagon head screw
9 2 Hexagon head screw
10 6 Spring washer
11 6 U-washer
12 2 U-washer
13 1 Spring
14 1 Spring washer
15 1 Lock washer
16 3 Spring washer
17 3 Hexagon head screw
18 1 Hexagon nut
19 1 Square nut
21 4 Hexagon nut
22 1 Guide washer
48
Remarks
Standardized connection for mounting console with ledge, column
or plane surface
Guides the roll with driver pin and rotates the lever arm
Mounting of pick-up bracket on actuator spindle
Assembly with roll (5) on lever (6)
Assembly with driver pin (4) on lever (6)
For stroke range 3 mm to 35 mm
For stroke ranges > 35 mm to 130 mm (special delivery), lever
6DR4004--8L is also required
Only for actuators with columns
M8 x 20 DIN 933--A2
M8 x 16 DIN 933--A2
A8 -- DIN 127--A2
B 5.4 -- DIN 125--A2
B 6.4 -- DIN 125--A2
VD--115E 0.70x11.3x32.7x3.5
A6 -- DIN 137A--A2
3.2 -- DIN 6799--A2
A6 -- DIN 127--A2
M6 x 25 DIN 933--A2
M6 -- DIN 934--A4
M6 -- DIN 557--A4
M8 -- DIN 934--A4
6.2x9.9x15x3.5
SIPART PS2
A5E00074600-05