Commissioning (See Leaflet "Operation -- A Concise Overview"); Preparation For Linear Actuators - Siemens SIPART PS2 6DR50x0 serie Betriebsanleitung

7

Commissioning (see Leaflet "Operation -- a concise overview")

Because of the numerous applications it can have, the positioner must be adapted to the actuator after assembly
(initialized). This initialization can be undertaken in three different ways:
Automatic initialization
-
The initialization is automatic. The positioner determines sequentially the direction of action, the travel or the
rotational angle, the travel times of the actuator and adapts the control parameters to the dynamic behavior
of the actuator.
Manual initialization
-
The travel or the rotational angle of the actuator can be set manually; the remaining parameters are automati-
cally determined as for automatic initialization. This function is required for soft end stops.
Copying initialization data (replacing the positioner)
-
For devices with HART function, the initialization data of a positioner can be read out and transmitted to
another positioner. Therefore it is possible to exchange a defective device without interrupting the running
process by an initialization.
Before initialization, you only have to set a few parameters for the positioner. The remaining parameters are set
with default values that you do not normally have to alter. If you observe the following points, you will not have
any problem with commissioning.
.
NOTE
You can return to the previous parameter by pressing the
7.1

Preparation for linear actuators

1. Mount the positioner with the appropriate mounting kit (see Chapter 3.2, page 48).
NOTICE
The position of the leverage ratio switch in the positioner is especially important and on page 95 in
the Leaflet "Operation -- a concise overview" point 7 of figure "View of device":
Stroke
5 to 20 mm
25 to 35 mm
40 to 130 mm
2. Push the driver pin (4, Figure 3, (page 50) 2) on the lever (6, Figure 3, 2) to the scale position corresponding
to the nominal stroke or the next highest scale position and screw the driver pin tight with the nut (18, Figure
3, 2).
3. Connect the actuator and positioner with the pneumatic cables and supply pneumatic power to the positioner
(see Chapter 6, page 54).
4. Connect a suitable current or voltage source (see Figure 10, page 98 to Figure 15, page 100).
5. The positioner is now in "P manual" mode. On the upper line of the display, the current potentiometer voltage
(P) is displayed as a percentage, e.g. "P37.5", and on the lower line "NOINI" is blinking:
Display:
6. Check that the mechanism is able to move freely over the entire setting range by moving the actuator into
each final position with the
.
NOTE
You can move the actuator quickly by pressing the other direction key while you hold the first direc-
tion key down.
SIPART PS2
A5E00074600-05
Lever Position of the leverage ratio switch
short 33° (i.e. below)
short 90° (i.e. above)
long 90° (i.e. above)
and keys.
Operating instructions
and keys simultaneously.
57