Alde Compact 3010 Bedienungsanleitung Seite 10

THE HEATING CARTRIDGES
$OO &RPSDFW V DUH ¿WWHG ZLWK WZR
230 V heating cartridges with a maximum
output of either 2100 or 3150 W. Select
the heating cartridge output on the control
panel.
Always check that the input fuse of the
vehicle has the correct amperage in
relation to the selected output. Note these
ratings are for the boiler only.
1050 W requires a 6 amp fuse.
2100 W requires a 10 amp fuse.
3150 W requires a 16 amp fuse.
THE CIRCULATION PUMP
A circulation pump is required to circulate
WKH KHDWHG JO\FRO ÀXLG 7KHUH DUH WKUHH
types of circulation pumps. A 12 V circula-
WLRQ SXPS FDQ EH ¿WWHG LQ WKH H[SDQVLRQ
tank, a 230 V or a 12 V circulation pump
FDQ EH ¿WWHG RQ WKH ERLOHU ,I PRUH WKDQ
one circulation pump is installed, the
required circulation pump is selected via
the control panel.
The control panel's room thermostat is
used to control the circulation pump, i.e.
switching on or off, depending on the
heating requirement.
SYSTEM TEMPERATURE
The boiler is set to a system temperature
of max 80°C, i.e. the temperature of the
JO\FRO ÀXLG as it circulates in the heating
system.
AIR CIRCULATION
In order to achieve the best possible result
from the principle of convected heat, it is
important to allow air to circulate freely
under bunks, and behind backrests and
wall-mounted cabinets. If the vehicle has
D ¿WWHG FDUSHW HQVXUH WKDW WKH FDUSHW GRHV
not obstruct the air supply to the radiators.
It is just as important that cushions or
EODQNHWV GR QRW LQWHUUXSW WKH ÀRZ RI DLU
behind backrests and wall cabinets.
Air stream
Convectors
10
MAINTAINING THE HEATING
SYSTEM
Wintercamping
While camping during the winter, ensure
WKDW WKH ÀXH LV NHSW FOHDU RI VQRZ DQG LFH
since the inlet air to the LPG boiler enters
WKURXJK WKH ÀXH 'R QRW VWDUW WKH /3*
ERLOHU XQWLO WKH ÀXH LV FRPSOHWHO\ IUHH RI
VQRZ $ ÀXH H[WHQVLRQ SDUW QR  
IRU ¿WWLQJ RQ WKH URRI LV UHFRPPHQGHG IRU
winter camping.
The LPG system
The LPG system should be checked regu-
larly by a professional, who will ensure
that there are no leaks from connections
or hoses.
LPG hoses should be changed accord-
ing to national regulations, maximum of
¿YH \HDUV &KHFN WKH GDWH VWDPS RQ WKH
hose. Hose has a propensity to dry out
and crack.
7R LQFUHDVH VDIHW\ ZH UHFRPPHQG ¿WWLQJ
an Alde leak gauge, type 4071, as close
as possible to the pressure reduction
valve.
Leak gauge, type 4071
The heating system
Regularly check the heating system's
ÀXLG OHYHO LQ WKH H[SDQVLRQ WDQN 7KH OHYHO
should be about 1cm above the minimum
indicator in a cold tank.
7KH KHDWLQJ V\VWHP VKRXOG EH ¿OOHG ZLWK D
mixture of water and glycol.
For preference, use high quality ready-
mixed glycol (with inhibitor) intended for
use in aluminium heating systems.
If using concentrated glycol, the mix-
ture should consist of 60% water and
40% glycol. If the heating system will be
exposed to temperatures below -25°C, the
glycol content must be increased, but not
to more than 50%.
Any vessels used for the liquid must be
spotlessly clean, and the pipes in the
heating system must be free of con-
tamination. This will prevent the growth of
bacteria in the system.
The glycol mixture should be changed
every second year, since its ability to
protect against corrosion, for example, will
deteriorate.
The glycol content should be checked
before topping up with new liquid. This will
ensure that the concentration of glycol in
the mixture is not too high.
,I WKH ÀXLG OHYHO LQ WKH H[SDQVLRQ WDQN IDOOV
for reasons other than evaporation, please
check all joints, drain cocks and bleeder
screws to ensure that they are not leaking.
If the glycol-water mixture leaks out, rinse
with water and wipe up.
Never allow the heating system to stand
empty of glycol.
FILLING THE SYSTEM WITH
GLYCOL FLUID
NB! $Q\ YHVVHOV XVHG WR FDUU\ WKH ÀXLG
must be spotlessly clean and the pipes in
the system must be free of contamination.
This will prevent the growth of bacteria in
the system.
7KH V\VWHP LV ¿OOHG WKURXJK WKH H[SDQVLRQ
WDQN HLWKHU PDQXDOO\ RU XVLQJ WKH $OGH ¿OO-
ing pump which both tops up and bleeds
WKH V\VWHP )RU PDQXDO ¿OOLQJ XQIDVWHQ
the circulation pump nut (R) and lift the
pump (S) out of the tank. Slowly pour the
glycol mixture into the tank. Bleed the
system. Top up with more liquid if the level
has fallen after bleeding. Bleed a newly-
¿OOHG V\VWHP UHJXODUO\ GXULQJ WKH ¿UVW GD\V
the heating system is in operation.
S
R