Final Work; Switching The Pc And Mc Xl Off And On Again; Connection Test Via Ping Command - Sirona inLab MC XL Handbuch

4 Final work

Switching the PC and MC XL off and on again

24
Operating MC XL via WLAN in the Ad-hoc mode CEREC / inLab MC XL
4
Final work
4.1 Switching the PC and MC XL off and on
again
1. Shut down the PC and switch it off.
2. Switch the milling unit off.
3. Switch the PC and the milling unit back on.
The configuration of the PC and the milling unit in the Ad-hoc mode is
completed.
4.2

Connection test via ping command

Click "Start" / "Run" in the task bar.
1.
Fig. 4-1 DOS prompt
Enter "cmd" in the following window.
2.
Confirm with "OK".
3.
The DOS prompt window then opens.
CAUTION: The IP address is only an example
The IP address in the next screenshot is only an example.
The IP address of the milling unit appears on the milling unit display when,
after turning the unit on, you press the "Config" key.
Enter the command "ping", followed by a space and the IP address of
4.
the milling unit.
Sirona Dental Systems GmbH
61 90 545 D 3439
D 3439.031.03.01.02 06.2007