Configuring The "Linksys Wet54G" Wlan Module - Sirona inLab MC XL Handbuch

2 Configuring the MC XL in the Ad-hoc mode

Configuring the "LINKSYS WET54G" WLAN module

Opening the Internet Explorer
Opening the Internet Explorer
IP address of the milling unit WLAN module
IP address of the milling unit WLAN
module
Login of the milling unit WLAN module
Login of the milling unit WLAN
module
10
Operating MC XL via WLAN in the Ad-hoc mode CEREC / inLab MC XL
2.3 Configuring the "LINKSYS WET54G"
WLAN module
Follow the instructions to set up the WLAN module for operation in the Ad-hoc
mode.
Click "Start" / "Programs" / "Internet Explorer".
The Internet Explorer window opens.
The IP address of the milling unit WLAN module is the sum of the milling unit
IP address plus 100.
The IP address of the milling unit appears on the display after you switch the
milling unit on by pressing the "Config" button.
Example:
IP address of milling unit
IP address of WLAN module
NOTE: New WLAN module or reset performed
After installing a new WLAN module or resetting the WLAN module, you must
use the following IP address: 192.168.1.226
1. Enter the IP address of the milling unit WLAN module in the address line
of the Internet Explorer window.
The login window of the milling unit WLAN module then opens.
2. Enter "admin" both as the user name and as the password.
Confirm with the "OK" button.
3.
Sirona Dental Systems GmbH
192.168.230 .120
+100
192.168.230 .220
61 90 545 D 3439
D 3439.031.03.01.02 06.2007