Making Biscuits; Straining Tomatoes - Silvercrest SFW 350 D3 Bedienungsanleitung

Making biscuits

After you have made the biscuit pastry according to your recipe, and after having
fixed the biscuit attachment 1:
1) Line a small baking tray with greaseproof paper and place or hold it directly
under the exit opening at the front of the appliance .
2) Press pastry evenly into the meat grinder casing 6 – the transport screw q
then pushes it through the selected design on the design motif strip of the
biscuit attachment 1 .
3) When the biscuit is the required length, stop the appliance and break the
pastry off at the exit opening . Lay the biscuits on the baking tray .
4) When you have read and understood all of the instructions on the topic
"Biscuits", you can now use the appliance as described in the chapter
"Operating the appliance" .

Straining tomatoes

1) Place a container under the tomato outlet 8 .
2) Place a container at the front under the strainer sieve 0 .
3) Quarter the tomatoes and push them into the meat grinder casing 6 slowly
and evenly .
The plastic screw 9 pushes the tomatoes through the strainer attachment .
The strained tomatoes fall into the tomato outlet 8 .
The tomato skin is ejected from the strainer sieve 0 at the front of the appli-
ance .
NOTE
If tomato juice starts leaking from the screw joints of the strainer attach-
ment, this can have the following causes:
–
–
–
► Try working more slowly, press the tomato pieces gently into the appliance
and cut the tomatoes into smaller pieces .
4) Once you have read and understood all of the instructions in the section
"Straining tomatoes", you can use the appliance as described in the section
"Operating the appliance" .
│ GB │ MT
■ 38
You are working too fast .
You are using too much pressure to press the tomato pieces into
the appliance .
The tomato pieces are too large .
SFW 350 D3