The Individual Functions; Setting The Film Speed - Gossen DIGISIX 2 Bedienungsanleitung

2

The individual functions

Press the function button for selecting the individual functions of the exposure meter. Each time
the button is pushed, the next function will be activated. The display panel will show the functions
in the following sequence:
 Ambient light 
only DIGIFLASH 2
The next function will only be activated after the function button has been released. When the
Function button is kept pressed down for more than two seconds, the settings of that function
are displayed and can be adjusted as desired.
2.1

Setting the film speed

 Select the function "Exposure ambient light" and hold down the function
button until the OK-signal sounds. The display will show ISO, blinking.
 Use the measuring key M to select the desired film speed.
When holding the key M pressed down, the film speed will automatically
be increased. When getting close to the desired ISO value, release the
key M and set the desired film speed by pushing the key in individual
steps. Each time you push the key, the film speed is increased by a 1/3
stop.
 Confirm the speed you selected by pushing the Function button until the
OK-signal sounds and the exposure meter returns to the function "Exposure ambient light".
10
 Timer  Watch  Alarm clock  Temperature 
Flash light
GOSSEN Foto- und Lichtmesstechnik GmbH