Function Timer - Gossen DIGISIX 2 Bedienungsanleitung

2.7

Function TIMER

A timer function is provided in the exposure meter, useful for long exposure or other timings ranging
from one second to thirty minutes.
 Use the function button to select the function TIMER and hold it down
until the OK-signal sounds. The display shows the last value used.
The read-out will show the "minutes" and will flash to allow the
countdown timer to be adjusted.
 Use the key M to enter the desired time in minutes. Confirm by
pushing the function button. The read-out "seconds" in the
display will flash.
 Enter the "seconds" of the desired length of time. Confirm by pressing
and holding the Function button until the OK-signal will sound. The timer
will now be in the Start/ Stop function.
 Push the key M to start the timer. The display will show the remaining time of the count-down. In
addition to that, during the last 10 seconds of the countdown, interrupted signals can be heard.
At the end of the set time, a continued signal will sound.
 To pause the count-down, push the measuring key; pressing it again will restart the count-down.
The timer will work in the background so that you can use other measurements.
16
GOSSEN Foto- und Lichtmesstechnik GmbH