Reely SKY SlowFlyer Bedienungsanleitung Seite 31

Rudder function
If the control stick for the rudder and elevator functions (see figure 2, item 5) is moved to the left, the rudder must deflect to the left. The rear rudder edge must
be deflected to the left by approx. 10 mm. In flight, the landing gear is pressed to the right and the model flies to the left (see figure 10).
If the control stick for the rudder and elevator functions (see figure 2, item 5) is moved to the right, the rudder must deflect to the right. The rear rudder edge must
be deflected to the right by approx. 10 mm. In flight, the landing gear is pressed to the left and the model flies to the right (see figure 11).
You have to slightly pull on the elevator control so that the model does not loose any height when going around bends.
Motor Function
Attention!
Ensure that no loose parts, such as paper, film or other objects can be sucked into the rotor during this motor test. Also make sure that the model
is held securely during this test run and that no body parts are within the rotation range or danger area of the rotor.
• Slide the control lever for the engine speed (also see figure 2, item 10) to the bottom position (engine off).
• Start up the transmitter and then the model.
• Push the control lever for the motor function slowly from the bottom to the top position. The rotor will start up and increase speed depending on control lever
position.
• When the control lever is at the top stop, the maximum rotor speed is reached. Then move the control lever back to the bottom-most position.
• Perform a brief engine test and check the run of the propeller and the propeller catch.
• Disconnect the flight battery from the model and switch off the transmitter.
Figure 10
Figure 11
31