Functional Description; Drill Safety Warnings - Makita DA3011F Bedienungsanleitung

30th January 2009
000230
Tomoyasu Kato
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, JAPAN
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.

DRILL SAFETY WARNINGS

1. Use auxiliary handle(s), if supplied with the
tool. Loss of control can cause personal injury.
2. Hold power
surfaces, when performing an operation
where the cutting accessory
hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
3. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
4. Hold the tool firmly.
5. Keep hands away from rotating parts.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
8. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Director
tool by insulated
may contact

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
Fig.1
CAUTION:
Before plugging in the tool, always check to see
•
GEA010-1
that the switch lever actuates properly and returns
to the "OFF" position when released.
To start the tool, simply squeeze the switch lever. Tool
speed is increased by increasing pressure on the switch
lever. Release the switch lever to stop.
A speed control screw is provided so that maximum tool
speed can be limited (variable).
Turn the speed control screw clockwise for higher speed,
and counterclockwise for lower speed.
Reversing switch action
GEB001-6
Fig.2
CAUTION:
Always check the rotational direction before
•
operation.
Use the reversing switch only after the tool comes
•
gripping
to a complete stop. It will damage the tool to
change the rotational direction before the tool
stops.
This tool has a reversing switch to change the rotational
direction.
the position (A side) for clockwise (forward) rotation
or the
rotation.
Lighting up the lamps
Fig.3
For Model DA3010F, DA3011F
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, start the tool. Then, the lamp lights
up the top of the bit. To turn it off, stop the tool.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
4
Move the reversing
position (B side) for counterclockwise (reverse)
switch lever to