Specifications - Makita DA4000LR Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Reversing switch lever
5-1. High
5-2. Low
6-1. Chuck key
6-2. Drill chuck
7-1. Hex wrench
7-2. Loosen
8-1. Angle housing

SPECIFICATIONS

Capacities
-1
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
8-2. Joint
8-3. Socket
8-4. Bolt
10-1. Two faces
10-2. Drill chuck
10-3. Spindle
11-1. Drill chuck
11-2. Chuck key
11-3. Hex wrench
Model
Steel
Wood
High
)
Low
Overall length
Net weight
Safety class
) : 80 dB(A)
pA
2
) : 2.5 m/s or less
h,D
2
ENE032-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG104-2
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG202-3
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Angle Drill
Model No./ Type: DA4000LR
are of series production and
3
11-4. Tighten
12-1. Drill chuck
12-2. Spindle
13-1. Drill chuck
13-2. Tighten
13-3. Chuck key
14-1. Limit mark
15-1. Brush holder cap
15-2. Screwdriver
DA4000LR
13 mm
38 mm
0 - 900
0 - 400
413 mm
4.0 kg
/II
Corporation as the
ENG901-1
ENH101-13
responsible