Installing The Appliance; Changing Over The Door Hinges; Note Ambient Temperature And Ventilation; Aligning The Appliance - Bosch KSW serie Gebrauchs- Und Montageanleitung

Installing the appliance

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
30 cm to an oil or solid‐fuel cooker.
Changing over the
door hinges
Fig. "
(if required)
Installation in numerical sequence.
Note ambient temperat­
ure and ventilation
The climatic class can be found on the
rating plate. It specifies the ambient tem­
peratures at which the appliance may be
operated.
Climatic
SN
N
ST
T
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Ventilation
Fig #
The air on the rear panel of the appli­
ance heats up. The warm air must be
able to escape. Otherwise, the refriger­
ator must work harder. This will increase
the power consumption.
For this reason pull up the spacers
provided on the appliance's rear panel
for the optimum distance to the wall
Fig. $
Never cover or block the ventilation
openings!

Aligning the appliance

Place the appliance in the designated
location and align.
Adjust the height‐adjustable feet with
a screwdriver.
Connecting
the appliance
After installing the appliance, wait at
least 1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220–240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
en
19