Setting The Time - hanseatic CM2065S Gebrauchsanleitung

Page GB-14 Start-up
(12)
1. Fill the coffee pot with fresh,
cold tap water.
2. Open the water tank lid (14)
and pour the water out of the
coffee pot into the water tank
up to the MAX mark on the
water level indicator (12).
Dry the coffee pot from the
outside and reposition it on the
hotplate (10).
PROG
STD
3. Press the AN/AUS button (4)
twice.
(14)
Ma x
12
10
PR OG
AN /AU
S
ST D
8
MIN
6
4
2
(10)
(3) (4)
AN/AUS
MIN
The control light (3) is illumi-
nated in red and the water will
begin to percolate through.
4. Once the water has percolated
through, press the button (4)
once again to switch off the
appliance.
The control light will go out.
Your coffee machine is now
ready for use.

Setting the time

If you wish to use the appliance
as a clock or use the "start time
delay" function, you must set the
time.
If you are connecting the device to
the power supply for the first time
or if the appliance was discon-
nected from the network,
will flash in the display.
(1) (2)
PROG
STD
(6) (5)
1. Push the AN/AUS button (4)
as often as required until the
control light (3) is no longer
flashing.
00: 0 0
(3) (4)
AN/AUS
MIN