Start Time Delay - hanseatic CM2065S Gebrauchsanleitung

Page GB-18 Operation
7. Press the AN/AUS button (4).
The control light (3) will be
illuminated in red and the
brewing process will begin.
8. If no more coffee drips out,
the brewing process has fin-
ished. You can now take out
the coffee pot and pour the
coffee.
9. If you want to keep the rest
of the coffee warm, place the
coffee pot back on the hot-
plate without switching off the
coffee machine.
10. To switch the appliance off,
press the AN/AUS button (4).
The control light (3) will go off.
If you do not switch off your
coffee machine, it will auto-
matically switch off after 40 min-
utes.

Start time delay

If you want the brewing process
to begin at a certain time, use the
start time delay.
Requirements:
– The current time has been set
(see „Setting the time" on page
GB-14).
– The appliance is in standby
mode (the display lights up, the
control light (3) does not).
Enter the start time
(1)
PROG
(6)
STD
1. Press the PROG button (1)
twice.
In the display, the cup symbol
will flash.
2. Set the desired start time with
the buttons STD (hours) (6)
and MIN (minutes) (5).
Around 5 seconds after you
last press the button, the set-
ting will be saved.
The control light (3) will be illu-
minated in blue; the start time
delay has now been activated.
If you disconnect the coffee
machine from the network,
the activation and setting of the
start time delay will be deleted.
(5)
MIN