NovoPress ACO202XL Betriebsanleitung Seite 27

7.6 Battery
Information!
The batteries are not charged at the factory.
Therefore:
– Charge the batteries before using for the first time.
Information!
Limited temperature range for charging and storing the batteries.
Therefore:
– It is imperative that the operating instructions for the battery charger are complied
7.6.1 Removing the battery (Fig. 2)
Push in (1) the two release buttons (A) and then remove the battery (2).
7.6.2 Inserting the battery (Fig. 3)
Slide the battery into the device as illustrated until it clicks into place.
7.6.3 Battery charge indicator (Fig. 2)
The battery charge is displayed when button (B) is pressed. The number of LEDs lit up denotes
the battery charge. One flashing LED indicates a maximum power reserve of 10 %. The battery
must be charged soon.
If the battery is inserted in the press device while the battery charge is being checked, the last
pressing operation must have been completed at least 1 minute prior to this. Otherwise the
display will be inaccurate.
7.7 ACO202XL and battery
Information!
The ACO202XL press device must only be operated with 18 V lithium-ion
rechargeable batteries. The 18 V battery must only be used in the
appropriate press devices.
Behaviour of the press device after extended periods out of use or when changing the
battery:
If the press device is out of use for approx. 30 minutes or the battery is reinserted, it switches
off. No LED is lit up any longer. Press the start button (1) briefly to start the press device.
Behaviour of the press device when the battery is empty:
When a pressing operation begins, a check is made to determine whether the battery charge is
sufficient to complete the pressing operation. If this is not the case the device does not start.
The green LED (2) flashes.
If the green LED (2) flashes following a pressing operation, the pressing operation was still
carried out correctly. The battery must be recharged prior to the next pressing operation.
with.
21
ACO202XL
EN