Disposal And Recycling; Troubleshooting Guide - Einhell Rg-Sa 1433 Originalbetriebsanleitung

Anleitung_RG_SA_1433_SPK7:_
GB
8.5 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Replacement cutting unit Art. No.: 34.211.08
Replacement aerating unit, Art. No.: 34.211.09

10. Troubleshooting guide

Fault
Motor does not start
Engine performance drops
Imprecise scarifying result
Motor is running, roller is not
rotating
Important notice! To protect the motor itis equipped with a thermal overload switch which cuts out
when overloaded and starts again automatically after a short cooling-down period.
18
09.09.2010 9:01 Uhr

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
Possible causes
a) No electricity in plug
b) Cable defective
c) Switch, switch/plug block
defective
d) Connections to motor or
capacitor disconnected
e) Housing clogged
a) Soil is too firm
b) Housing clogged
c) Roller badly worn
a) roller worn
b) Wrong working depth
a) Toothed belt is torn
Seite 18
Rectification
a) Check line and fuse
b) Check
c) Have machine checked by a
customer service center
d) Have machine checked by a
customer service center
e) If necessary adjust working depth.
Clean housing so that the roller can
run freely
a) Change working depth
b) Clean housing
c) Replace roller
a) Replace roller
b) Correct working depth
a) By customer service workshop