TELECOMANDO 40176 Bedienungsanleitung Seite 43

REMOTE CONTROL EN
43
Trouble:
Occurs when the pressostat switch detects a pressure / vacuum below the safety threshold,
because of it:
 Check the connections to the switch and that the outlet static pressure functions.
 Check that the door is closed and the seals are not worn.
 Check that the door of the overpressure, located above the combustion chamber is
closed.
 Check that the connecting channel and the flue are connected and perfectly clean.
 Check that the flue is not obstructed.
Solution:
 Check the causes.
 If the problem persists, contact technical support.
Trouble:
The radio control does not communicate with the control unit, because of it:
 Check the main switch on appliance's rear panel being
 Check fuses (4A) located near the main switch and on the electronic board .
 Loss of remote control synchronization (see section 3).
Solution:
 Check the causes.
 If the problem persists, contact technical support.
Trouble:
Water temperature too high.
Solution:
 The unit will automatically turn off and on again when the water temperature is within
only for hydro
the standard values.
devices
 If the problem persists, contact the plumbing technician who has run the system.
Trouble:
It occurs when left open the loading door of the pellet tank for more than 180 seconds. The
display will scroll the following message and the device is in power off..
Solution:
only models
 Close the pellet loading door.
with sealed
 If the problem persists, contact technical support.
chamber, type B