Menu' M10 Engineer Settings; Menu' M11 Dealer Settings (If Available); Menu' M12 Enable Blower (If Available); First Starting - Telecomando 40176 Bedienungsanleitung

REMOTE CONTROL
STATE 1 = UNIT IN LIGHTING
STATE 2 = UNIT IN WAIT PREHEAT
STATE 3 = UNIT IN FIRE ON
STATE 4 = UNIT IN WORK
STATE 5 = UNIT IN FIRE-POT CLEANING
STATE 6 = UNIT IN FINAL CLEANING
STATE 7 = UNIT IN WAIT COOLING STAND-BY
STATE 8 = UNIT IN ALARM IN PROGRESS
STATE 9 = UNIT IN MEMORY ALARM

21. MENU' M10 ENGINEER SETTINGS

This menu is under code and is reserved to a Technical Service

22. MENU' M11 DEALER SETTINGS (if available)

This menu is under code and is reserved to a Dealer

23. MENU' M12 ENABLE BLOWER (if available)

This menu item (if available) can be enabled (ON) or disable (OFF) the air blower.
If the fan is disabled (OFF), the unit will operate at power 1 or 2 or 3 max (you can
not set the power 4 or 5). Warning: Only the type models B6 - B9 - B10 (sealed chamber)
allow the disabling of the fan (OFF). In all other models always leave the fan enabled (ON)
to avoid overheating and possible damage.
°
To modify

24. FIRST STARTING

Fill the tank up with pellet before starting the stove. Remember the feeding screw is empty and a longer time is
needed when first starting the stove. Run the relevant menu.
When first burning the stove, you can feel bad smells in the room but all the
protection greases used during production procedure are burning out. Do ventilate the
room and do not stay in till smells cannot be felt. In order to supply you with the best possible
product, al paints are water based and no harmful thinners are used.
SWITCHING ON

Before performing ignition, make sure that the burning pot is completely free,
clean of any pellet residue and correctly positioned.
 The accumulated unburnt pellets in the bracier must be removed before proceeding with a new ignition.
 Do not fed manually into the bracier pellets or any other type of fuel.
Until to....
EN
39