Changing The Heating Power Set; Changing The Temperature; Changing The Water Temperature (Only Hydro Devices); Air Fan (Only Hydro Equipment, If Present On The Unit) - Telecomando 40176 Bedienungsanleitung

REMOTE CONTROL
Unit in status work
After the flue gas temperature has reached and exceeded the factory set , the heater goes into the work that is the
normal mode of operation. The display shows the word "Work". Once you reach the temperature set at the factory,
the fan / heat exchanger turns at the speed set according to power .(led exchanger on).
WORK
For proper operation, the generator will automatically clean the burner with intervals set by the manufacturer and can
not be modified. On disply appears the following message and the LED screw is on. This process takes a few
seconds
FIRE-POT CLEANING

4. CHANGING THE HEATING POWER SET

During normal operation of the unit (work) you can change the heat power emitted by pressing:
- For AIR DEVICES: press the button P5 and P6. To increase the heating power press P6 again, and to reduce
press P5. Power from 1 to 5.
- For HYDRO DEVICES: press the button P6. To increase or reduce the heating power press P5 and P6 again.
Power from 1 to 9.
The power level is set on the display.
To exit from the set wait 5 seconds without performing any operations on the keyboard, or press P3.
SET POWER

5. CHANGING THE TEMPERATURE

To change the room temperature act on:
- FOR AIR DEVICES press the button P1 and P2.
- FOR HYDRO DEVICES press button P2 and then button P1 and P2 to modify.
Warning: in the hydro equipment, the air blower is turned on or off, depending on this set room
temperature; if put the AUTO value, the ventilation modulates with the combustion and therefore in
function of the water temperature alone.
The display shows the set temperature (numbers). This acting on the button P2 (reduce ) and P1 (increase) you can
change the value. After about 5 seconds the value is stored and the display returns to the normal display, or press to
exit P3.
SET ROOM TEMP

6. CHANGING THE WATER TEMPERATURE (only hydro devices)

To change the temperature of water is sufficient to act on the button 1.
The display shows the set temperature water (SET temperature). Thus acting on the keys 2 (decrease) and 1
(increases), you can change its value. After about 5 seconds the value is stored and the display returns to the normal
display, or to exit, press button 3.
SET TEMP WATER

7. AIR FAN (only hydro equipment, if present on the unit)

To change the speed of the air fan, simply press the 5 key, and then act on the 5 and 6 button to change the value
from OFF, 1, 2, 3, 4, 5 or AUTO.
OFF = OFF, 1 = minimum speed, 5 = maximum speed , AUTO is set with the power of the device.
EN
27