TELECOMANDO 40176 Bedienungsanleitung Seite 42

EN
42
 check for pellet quality
 check for overpressure switch, could be off because of dirty smoke outlet. Could a sign
 the smoke extractor doesn't work properly
 check for the safety thermostat
Solution:
 Check the causes.
 If the problem persists, contact technical support.
Trouble:
The pellet does not fall into the brazier, because of it:
 check for pellet tank being loaded.
 check for loading screw motor not being blocked.
 check for loading screw is not blocked.
 check the main board.
Solution:
 Check the causes.
 If the problem persists, contact technical support.
Trouble:
Occurs when the general safety thermostat detects a temperature higher than the fixed level
of security set by the manufacturer, because of it:
 The chimney may be obstructed
 Canvas or different objects laid on the appliances.
 Install the appliance in a niche without proper ventilation
 Lack of ventilation grids on the coating (inserts and fireplaces).
 Thermostat temperature probe defective.
Solution:
 Check the causes.
 If the problem persists, contact technical support.
 To quit the error signal follow the procedure:
1) unscrew protection cup 2) press safety thermostat
button
REMOTE CONTROL
3) screw the protection up.