Declarations Of Conformity - scaltec sba 31 Installation Und Betriebsanleitung

Declarations of Conformity

Council Directives of the EU and European Standards:
This SCALTEC balance meets the requirements of the following
Directives issued by the Council of the European Union.
Council Directive 89/336/EU "Electomagnetic compatibility (EMC)"
Important Note:
The operator shall be responsible for any modifications to SCALTEC equipment
and for any connections of cables or equipment not supplied by SCALTEC
and must check and, if necessary, correct these modifications and connections.
On request, SCALTEC will provide information on the minimum
operating specifications (in accordance with the Standards listed above
for defined immunity to interference).
73/23/EEC "Electrical equipment designed for use within certain
voltage limits"
If you use electrical equipment in installations and under ambient conditions
requiring higher safety standards, you must comply with the provisions
as specified in the applicable regulations for installations in your country.
For information on the current legal requirements of your country,
please contact your local SCALTEC customer service office.
Additional Directive for Weighing Instruments Used in Legal Metrology:
Directive 90/384/EEC "Non-automatic weighing instruments"
This Directive also regulates the performance of the EC verification by the
manufacturer, provided that an EC Type-Approval Certificate has been issued
(see page 72) and the manufacturer has been accredited by an officer of a
Notified Body registered at the Commission of the European Community for
performing such verification. On February 15, 1993, the manufacturers
received accreditation for performing verification.
Subsequent Verifications within the European Countries
The validity of the verification will become void in accordance with the national
regulations of the country in which the balance is used. For information on
verification and legal regulations currently applicable in your country, and to
obtain the names of the persons to contact, please contact your local SCALTEC
office, dealer or service center.
71