8.
Commissioning
a) Remove Car Body, Place Aerial Cable, Install Rear Spoiler
Now remove the car body. Remove the safety clips and
take off the body upwards.
If the aerial cable is still inside the battery/receiver box, re-
move the two safety clips (see arrows in the figure on the
B
A
right) and remove the lid (A) of the battery/receiver box.
Guide the aerial cable from the side of the battery/receiver
box and through the aerial tube (B). Plug the aerial tube in
C
the lateral holder (C).
For a wide range, the aerial needs to protrude from the
vehicle at the top.
Never shorten the aerial cable! Never coil the aerial cable!
This greatly reduces the range.
The rear spoiler is delivered separately from the vehicle.
Fasten it to the vehicle with the enclosed assembly set.
The nuts are pushed into small openings below the rear
spoiler holder. Then put the rear spoiler on the rear spoiler
holder.
Push the screw through the washer and the plastic holder
and fasten the rear spoiler to the vehicle.
45