Renkforce 808577 Bedienungsanleitung Seite 59

The recording ends when the screen/DVR has no longer recognised any motion for a duration of about
10-15 seconds.
3. „Schedule"
You can set a specific time here at which a recording is to take place automatically (time-controlled re-
cording). It is possible to programme only one specific day (e.g. next Saturday) or have the recording take
place every day (e.g. 8:00 AM to 6:00 PM).
The recording of pictures is only possible in the operating mode „One Key". If you chose the
operating mode „Motion Detect" or „Schedule" in the function „Recording mode", the recording
of videos is activated automatically.
Proceed as follows:
• Use the buttons „2" and „8" to pick the function „Recording Mode" and then push „
• Use the buttons „2" and „8" to set the desired operating mode („One Key", „Motion Detect" or „Sche-
dule"), see description above.
• Confirm the selection with „
If the operating mode „Schedule" was chosen, set when the automatic recording is to take place.
This setting can be made separately for channel 1 („CH1") and channel 2 („CH2").
First use the buttons „2" and „8" to choose between channel 1 („CH1") and channel 2 („CH2");
the respective active channel is marked with a red frame.
Push this button „
Use the buttons „2" and „8" to switch between „Disable" (automatic recording disabled),
„ONCE" (record once on a special date) and „WEEKLY" (weekly repetition of the set period, e.g.
Monday to Wednesday).
Use the buttons „4" and „6" to switch the respective active input item (marked red); the buttons
„2" and „8" change the respective value.
At the very right, you can switch between „CONT" (continuous recording) and „MOTION" (recor-
ding at motion detection).
Push this button „
If the message „Time Conflict, try again!" appears, the date or time input for automatic recording
has caused a conflict, i.e. an overlap or wrong input. This may happen, e.g. if the start time/date
is before the current time/date.
• Push the button „MENU/ESC" on the screen/DVR or the button „MENU" on the IR remote control re-
peatedly to return to the respective previous menu or leave the OSD menu.
".
" to start the settings.
" to terminate the settings.
".
57