Waeco PerfectView M511L Montage- Und Bedienungsanleitung Seite 23

PerfectView M511L
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
Secure the monitor in such a way that it cannot become loose under any
circumstances (sudden braking, accidents) and cause injuries to the occupants of
the vehicle.
Do not attach the monitor in the area that may be used by an airbag, as this could
cause injury if the airbags are triggered.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(1 1, page 3) or a voltmeter (1 2, page 3).
Test lamps with an illuminant (1 3, page 3) take up voltages which are too high and
which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (3, page 4).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape, for
example to existing cables.
Observe the following instructions when handling the LCD monitor:
Do not open the monitor (4, page 4).
Do not submerge the monitor in water (5, page 4); the monitor is not waterproof.
The monitor may not impair your vision when driving (8, page 5).
Do not use the monitor when you are driving.
Do not operate the monitor with wet hands.
Do not operate the monitor if the housing has been damaged.
Connect it to the correct voltage.
Do not use the monitor during storms (especially during thunderstorms).
Do not use the monitor in areas which
– are subjected to direct sunlight,
– are subject to strong temperature fluctuations,
– have high levels of humidity,
– are poorly ventilated,
– are dusty or oily.
Safety and installation instructions
23