Connecting The Monitor To An Electricity Supply - Waeco PerfectView M511L Montage- Und Bedienungsanleitung

Mounting the LCD monitor
➤
Hold the monitor bracket within the outlines marked beforehand and mark
four different drilling points.
➤
Drill Ø 2 mm holes at the points you have just marked.
➤
Screw the monitor bracket on with the 4 x 20 mm self-tapping screws.
➤
Push the monitor (c 1, page 5) onto the mounting plate of the monitor
bracket (c 2, page 5) and secure it on the monitor bracket with the knurled screw
(c 3, page 5).
You can now adjust the angle of inclination. To do this, loosen the
knurled screw (c 4, page 5) and tilt the monitor to the desired position.
Tighten the knurled screw (c 4, page 5).
6.3

Connecting the monitor to an electricity supply

The circuit diagram for the LCD monitor can be found in d, page 8.
No. in d,
page 8
1
2
3
4
5
6
7
8
9
10
Observe the following instructions when laying out the connection cable:
Feed the connection cable through existing ducts or other openings where
possible e.g. ventilation grids. If no appropriate ducts or openings are
available you will need to drill a hole of Ø 20 mm. Check beforehand that
there is sufficient room for the drill head to come out on the other side (2,
page 4).
Cables and connections which are not properly installed will cause
malfunctions or damage to components. Correct installation of cables
and connections is the basic prerequisite for lasting and trouble-free operation
of the retrofitted components.
To prevent damage to the cables, when laying them ensure that there is sufficient
distance to hot vehicle components (lights, heaters, ventilators etc.).
28
Description
Monitor
5 pin mini-DIN plug
Connection cable
5 pin mini-DIN socket
12 V positive cable (red): connection to the positive pole of the
voltage source
Earth cable (black): connection to the negative pole of the
voltage source
6 pin DIN socket (connection to video source 1)
6 pin DIN socket (connection to video source 2)
Cable (green): control input for the connection to the
reversing light (possible voltage range from 12 V to 32 V)
Cable (violet): control input for inverting the picture
(camera: RV-24, RV-27, RV-29-T130)
PerfectView M511L