Connecting The Monitor To An Electricity Supply - Waeco PerfectView M71L Montage- Und Bedienungsanleitung

Mounting the LCD monitor
➤
Hold the monitor bracket within the outlines marked beforehand and mark four
different drilling points.
➤
Drill 2 mm diameter holes at the points you just marked.
➤
Screw on the monitor bracket with the 4 x 20 mm self-tapping screws.
➤
Slide the monitor (1) onto the mounting plate of the monitor bracket (2) and
secure it on the monitor bracket with the knurled screw (3).
I Note
You can now adjust the angle of inclination. To do this, loosen the knurled
screw (4) and tilt the monitor to the desired position. Tighten the knurled
screw (4).
6.3

Connecting the monitor to an electricity supply

The circuit diagram for the LCD monitor can be found in fig. b, page 7.
No. in
fig. b, page 7
1
2
3
4
5
6
7
8
9
10
26
Description
Monitor
9-pin Mini-DIN plug
Connection cable
9-pin Mini-DIN socket
12 V positive cable (red): Connection to the positive pole of the
voltage source
Earth cable (black): Connection to the negative pole of the volt-
age source
6-pin Mini-DIN socket (connection to video source 1)
6-pin Mini-DIN socket (connection to video source 2)
Cable (green): Control input for the connection to the reversing
lights
Cable (violet): Control input for inverting the picture
(Camera: RV-24/N, RV-27/N, RV-30K, RV-30K-F)
PerfectView M71L