Transport; Storage - Kärcher K 5.610 Originalbetriebsanleitung


Illustration
Remove the lid from the Plug 'n' Clean de-
tergent bottle and press the detergent bot-
tle into the detergent connection with the
opening facing down.

Illustration
Adjust the suction volume of the detergent
solution by means of the dosage regulator
for detergents.

Use spray lance with pressure regulation
(Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with the
water stream.
Note: If required, the washing brushes can be
used to work with detergent.
Recommended cleaning method

Spray the detergent sparingly on the dry
surface and allow it to react, but not to dry.

Spray off loosened dirt with the high-pres-
sure jet.
Interrupting operation

Release the lever on the trigger gun.

Lock the lever on the trigger gun.

During longer breaks (more than 5 min-
utes), also turn the appliance off using the
"0/OFF" switch.

Insert the trigger gun in its holder.
Finish operation
Caution
Only separate the high-pressure hose from
the trigger gun or the appliance while there is
no pressure in the system.

Remove the Plug 'n' Clean detergent bot-
tle from the intake and close it with the lid.
To store, place into the intake rotated by
180°.

Release the lever on the trigger gun.

Turn off the appliance "0/OFF".

Turn off tap.
 Detach the appliance from the water supply.
Caution: When disconnecting the supply
or high pressure hose, warm water may
leak from the connections after operation.

Press the lever on the trigger gun to release
any remaining pressure in the system.

Lock the lever on the trigger gun.

Pull out the mains plug.
18
Caution
In order to prevent accidents or injuries, keep
in mind the weight of the appliance during
transport (see Specifications).
When transporting by hand

Lift appliance by the carrying handle and
carry it.

Pull the appliance by its transport handle.
When transporting in vehicles

Prior to horizontal transport: Remove the
Plug 'n' Clean detergent bottle from the in-
take and close it with the lid.

Secure the appliance against shifting and
tipping over.
Caution
In order to prevent accidents or injuries, keep
in mind the weight of the appliance when se-
lecting a storage location for it (see Specifica-
tions).
Storing the Appliance

Park the machine on an even surface.

Press the disconnect on the hand spray
gun and remove the high pressure hose
from the hand spray gun.

Push the casing of the quick coupling for
the high pressure hose toward the rear
and disconnect the high pressure hose
from the appliance.

Insert the hand spray gun with the spray
lance into the holder for the hand spray
gun.

Stow away the mains cable, the high-
pressure hose and accessory at the appli-
ance.
Prior to extended storage periods, as during
the winter, also observe the instructions in the
Care section.
– 6
EN

Transport

Storage