Universal
9" / 12"
User manual / Bedienungsanleitung
2. Universal
– tonearm mounting
(9" and 12")
Please keep in mind that the following instructions are covering the mount of the
Universal
tonearm on any Clearaudio turntable. Installation on other brand turntables is
possible but not covered in this manual.
Please refer to the turntable manufacturer´s user manual.
2.1 Universal tonearm with VTA – Lifter:
Pic. 2: Universal with VTA-Lifter
1).
Slide the VTA-Lifter into the drilling of the tonearm base. Lock the VTA-Lifter with the screws
on the side of the tonearm base (pic. 3 and 4).
Pic. 3: Set-up of tonearm base with VTA-Lifter
To adjust the height of the tonearm in the
VTA-Lifter lift the VTA-Lifter up and loosen the
screws.
After adjustment of the tonearm height tighten
the screw again.
Pic. 4: Adjustment of the height of tonearm with VTA-Lifter
Seite/Page 5
clearaudio electronic GmbH 2014